SCANMASTER ELM PID CONFIG MOD

Please help complete pin features depending on car makes:Дў -> any make not as sae j1850+ but as k line?Д¦ -> any make not as can high but as k line?ДЎ0 -> any make not as sae j1850- but as k line?ДЎ4 -> any make not as can high but as k line? It's ok, so then use a 1P12T rotary switch instead, we can add 4 more posibilities for k line like this:ДЎ1 -> mb transmission, fiat alarm + lock doorsДЎ2 -> opel airbag + abs, fiat engine bay wiringДЎ3 -> EEC5 reprogramming, fiat rear wiring Pin 11 is always transmission on mercs & pin 13 on EEC5 for reprogramming, they do a 12 to 1 rotary switch so it would be ideal to keep all options open (note that these two commands don't revert programmable parameters to default values, even after reset or power off/on, you got to set them to default values by hand, see default values in the picture above) To disable all parameters (set them off): atppffoff

Programmable parameter 2A only available from ELM327 1.3 or upper firmware version (edit: this is not true, also available for ELM327 v1.2a)Д®dit: AT command to show current programmable parameters: atppsД 0:FF F 01:FF F 02:FF F 03:32 F means off (disabled), N means on (enabled)

SCANMASTER ELM PID CONFIG MOD

AT commands for FORD ELM327 CAN pin selection mod

Scanmaster elm pid config